Grind Tower
€189.00
Available, delivery time: 1-2 weeks
Product number:
N4656.3
Product information "Grind Tower"
Electric needle sharpener and repair device, developed and manufactured by Ralph-Torsten Kolmer
Model variants:
- Suitable for 0.2 mm nozzle sets
- Suitable for 0.15 mm nozzle sets from Harder & Steenbeck Infinity.
- Suitable for 0.2 mm and 0.15 mm nozzle sets.
- Retrofit lid for converting the 0.2 mm device for 0.15 mm needles
Scope of delivery of the Grind Tower: Grind Tower with stand, one needle guide and one grinding disc with 400 grit, one power supply unit and one additional grinding disc with 600 grit, tool for adjusting the height or depth stop of the grinding disc, needle clamp and operating instructions.
The back of the defective needle is inserted into the needle clamping piece and then pushed into the stop. To increase the needle's resistance to damage, it is first ground blunt. Carefully push the needle into the guide provided and when the grinding noise occurs, slowly rotate the needle through 360 degrees several times until the grinding noise is reduced. The sealing cone of the needle is then ground. This is done on the other side of the needle guide plate and the grind tower must be rotated 180 degrees. The grinding process is similar here - grind again and rotate 360 degrees until the grinding noise is reduced. Finally, you should ideally polish the needle tip.
German instruction video: https://youtu.be/Kl3h_7Ue7gE
Further information and accessories (German only): https://airbrushschule-sueddeutschland.de/grind-tower
Grind Tower: Nie wieder eine neue Nadel kaufen!
Der neue, elektrische „Grind-Tower“, entwickelt und gebaut von ASBS Autor Ralph-Torsten Kolmer